Chemical Free Self-cleaning Electrolytic Scale Remover for Swimming Pool Water Treatment

October 23, 2019 at 6:33 PMadmin
The pool water should not be softened. If it is softened, there is no calcium ions or magnesium in the water, the hardness and electrical conductivity are so low that the process of electrolysis will be slow, resulting in poor effect. [More]

Chemical Free Fully Automatic Electrolytic Scale Remover (Tiaano ElSr-SC)

October 19, 2019 at 3:16 PMadmin
Unit responsibility of complete package by Tiaano. Unit means, responsibility for interfacing and successful operation of all components of ElSr supplied by Tiaano. [More]

Chemical Free Self-Cleaning Electrolytic Scale Remover – System operation

October 18, 2019 at 5:45 PMadmin
The treatment system must operate using the electrolysis principle with the electro chemical reactor, consisting electrolyzer of anode and cathodes. Water to flow through the reactor between the cathode and anode, continuously for electrical current to flow and cause the dissociation of the salts in the water into ions, should also precipitate all scale forming ions, not just magnesium and calcium but other ions that are susceptible to dropping out of the liquid at high pH viz., Silica, Ferum, Manganese etc. [More]

Our Newly designed Chemical Free self-cleaning Electrolytic Scale Remover for cooling tower water treatment

October 16, 2019 at 11:33 AMadmin
Tiaano incepted on 1992, installed over 5000 electrochemical water treatment systems in 63 countries. Chemical free self-cleaning (Fully Automatic) Electrolytic Scale Remover, our new innovative product is an online treatment system, widely accepted product designed for the application of cooling tower water treatment. [More]

Special Characteristics of Tiaano’s Chemical Free Electrolytic Scale Remover used for Cooling Tower Water Treatment System

October 14, 2019 at 4:40 PMadmin
Indian engineering & production follows science & Technology of Israel. [More]

Which parameters to be considered to take blow down? (TDS or conductivity)?

October 12, 2019 at 3:37 PMadmin
Normally in chemical dozing they take blow down when conductivity reaching 2000 μs / cm. But when using ElSr, our recommendation to blow down the water when the conductivity reaching between 4000 &4500 μs / cm. [More]

Does ElSr system take care of BOD & COD?

October 11, 2019 at 4:22 PMadmin
Our system can do ionization, precipitation and chlorination. Because of Ionization in ElSr, scale precipitation occurs; once the scale is precipitated, it never adheres to the Condensers / cooling tower Water distribution system. Chlorine (Sodium hypochlorite) production helps to prevent the growth of bacteria and algae. [More]

Posted in: FAQ

Tags:

PERFORMANCE REPORT ON TIAANO’S CHEMICAL FREE ELECTROLYTIC SCALE REMOVER GIVEN BY M/S. ISRO on HOT WATER TREATMENT SYSTEM

October 10, 2019 at 5:56 PMadmin
During this 650 Hrs. treatment, the ElSr system protects corrosion on the wall of the HWCS Tank. Also removed the existing scale (fouling) on the Heater coil. Hence the Tiaano’s ElSr system can separates the scale accumulated on the accessories like Heater, Condenser, Hot water circuits and makes corrosion free. [More]

Tiaano’s Chemical Free Electrolytic Scale Remover Installation in Textile Mills for the Application of Humidification Spray Chamber

October 9, 2019 at 5:35 PMadmin
ue to the recirculation of water in the process, all the conductive salts (scale) deposited in the Pipe lines & the Spray nozzles. In due course the pipelines are getting deteriorated. [More]

What range of TDS water should have container water?

October 8, 2019 at 10:44 AMadmin
TDS should have minimum 350 ppm in the feed water. [More]

Posted in: Anode | Cathode | Photo Gallery | FAQ | General Information | Tiaano

Tags: , , , , , , , , , , ,